ADIC SNC 5100 Guia do Utilizador descarregar pdf (Página 173)

Commands 165

6-00020-02

SNC 5100

sfmAccessClear [disable code]

The

sfmAccessClear command disables all host access to all LUNs except to

LUN 0 (the Command and Control interface). The disable code is 0xfacade02.

The following command example shows how to disable all access.

SN60023 >sfmAccessClear 0xfacade02

value=0=0x0

SN60023 >

sfmAccessSet [hostindex],<Starting LUN>,<Ending

LUN>,<Access>

The sfmAccessSet command sets the access for the specified range of LUNs

for the specified host connection index.

When you enter this command, the settings are stored in memory but are not

applied until you enter the sfmAccessApply command. The following

example shows how to enable the host at connection index 1 to access LUNs 2

through 32. Existing hostindex values can be determined by looking at the “Id”

column in the output of the sfmShow -1 command.

SN60023 > sfmAccessSet 1,2,32,1

value=0=0x0

SN60023 >

sfmActiveSet

The

sfmActiveSet command places SFM in the active state. The means that

all of the current access settings are put into effect. You would typically only

use this command after making SFM inactive. See the

sfmInactiveSet

command.

SN60023 > sfmActiveSet

value=0=0x0

Access Value

0 Disables access to the LUNs

1 Enables access to the LUNs

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 227 228

Sem comentários

ADIC SNC 5100 Guia do Utilizador Página 173